Pointed End Cap

Use a pointed bottom cap to drive screen down into the sand or slurry at the bottom of your well. Our pointed bottom caps are made from Class 18 PVC and screw right onto our screen or casing. With a sharp point they can be pushed to the bottom of the intended well to set the PVC screen at the correct position. Available for 50mm PVC only ...Download brochure

BellBoy

Tough, Low Cost End Cap The Bellboy end cap is made of thick walled, hard plastic with a full domed shape. This allows you to pound the PVC down to the bottom of the hole to get the screen into the right depth. The Bellboy cap is tapped inside the ID of the PVC pipe where it gets held frmly inplace by 4 raised lugs around its circumference...Download brochure

Centralisers

To center pipe in the bore Two types of centraliser are available to ensure that instruments and casing remain centered in the borehole. KwikZip centralisers are Australian made. They self clamp around the pipe in seconds as shown below. They can be put anywhere along the casing or screen. No pins or bolts required. Star Centralisers are made from 2mm thick PVC sheet. The star shape allows sand and other materials to pour through them. They have a central hole that the male thread of the PVC pipe goes through. It is clamped in place when the next female thread is screwed over it ...Download brochure

Torquer Well Plugs

Now available in two sizes: • 50mm wells • 100mm wells The Torquer locking I.D. plug truly locks well. In addition the Torquer plug is manufactured out of a glass reinforced polymer for additional strength. Incorporated is a large wing nut design for ease of installation and removal. The plug is water tight, fuorescent orange (helps locate well) and are priced to save money ...Download brochure

J-Plug

The Tried & True Standard...Download brochure

H Cap

No Padlock, Unique Key Well Cap with Built-in Security...Download brochure

Grip ‘n Lock Well Caps

These are very similar to the popular ‘Snap Caps’, except they are bright orange in colour and require no glue or binding material to fx it to the PVC riser. You merely tap it on with a rubber hammer, over the end of the PVC pipe. The internal barbs grip the OD of the PVC pipe. The result is a non-rusting, highly visible environmentally protective riser pipe.When fastened in position and padlocked, the Grip ‘n Lock cannot be opened without physically breaking the cap. This ensures easy detection of any unauthorised entry to the well ...Download brochure

Brass and Aluminium Lockable Well Cap

This 2-piece Brass and Aluminium Locking Well Cap provides tamper- proof and leak resistance protection for use on 50mm stainless steel or PVC well installations. The aluminium cover is clearly marked with the triangular monitoring well warning symbol and "Test Well".The brass adaptor is tapped onto the monitor casing and the special barbed design provides permanent attachment. The aluminium cap is threaded to the adaptor providing a lockable and water resistant seal. The cap and adaptor are ftted with Buna-N gasket. Locks sold separately ...Download brochure

Ex-Cap Vapour or Water Extraction Well Plugs

The Ex-Cap is a self-sealing vapour sampling cap that takes the place of a standard monitoring well cap where vapour or water monitoring is required. It operates as a watertight locking expansion plug with the capability of having vapour (Ex-Cap for Air) or water (Ex- Cap for Water) extracted through the cap, without removing the cap from the well ...Download brochure

Request a quote or more information